i5-4210U+GT840M renderer using MadVR
When looking at the recent Fan is not always satisfied with the screen's color rendering, I think both the old and the new Fan Fan, this color can then fine few. Well, but since my HP is low with this pit father, nuclear was to see Fan can reach 30FPS up and down, watching alone was a fan on 1FPS. It remains to face what they are called graphics card ah?
Today, suddenly saw MadVR this renderer, the perfect support PotPlayer, so wanted to try it out. But behind the beautiful delicate images must be the performance of the hardware support, I do not know my laptop can sustain long, can render Chengshayang, you think, the lowest ABZU with five minutes overheating blue screen, but also when looking Fan Hand Po with, I am afraid that no matter how optimization is not able to render hardware with low, or even M6000, GTX1080, Titan doing, take direct optimization, the k620 on the line, right?
Without further ado, we direct to configure the installation MadVR it, then I will use Night on the Galactic Railroad VCB-s subtitle group to be tested. The current version is 1.6.63891 PotPlayer, use 64-bit. MadV Yes. . what. . . Yep. . . . I feel like I did not find any version number. Anyway, today is downloaded. madVR installation is very simple, unpack, and then run inside install.bat can use administrator privileges. By the way, LAV separator installed myself, but I do not know the impact of this separator for madVR, and that time I try to try several times to see it. MadVR open with administrator privileges that came with madLevelsTweaker.exe after the installation is complete, the Force PC levels open, you can then click apply. Then open madHcCtrl.exe, into this page (task bar icon, right, first):
device type usually choose the second digital monitor/TV on the line, as the latter setting, uncalibrated, 8bit color depth like, if you have a cautious tone, please see this article (to be over the wall). I have this notebook screen is not fine tune.
Here are enabled madVR in PotPlayer in. In PotPlayer setup (F5 open) and the LAV Vedio Decoder madVR a forced open to the global priority of the filter.
The way you can in the video - Select Madshi video rendering rendering mode. Anyway, eventually when the video player to see the renderer is madVR, LAV decoder is on the right, as shown below.
like this. Nvidia calls on the laptop issue of independence was, I did not come across, set up a high-performance graphics card can run in the NVIDIA control panel, but I doubt very much that this is not a high-performance graphics cards. But fancy map can be found in the video output is zero jitter 70FPS, jitter do not know where to go higher than before, fps do not know the internal decoder and rendering low to go there, then it is pretty much (data only).
Picture point of view, it seems clear that the subtitle is a Diudiu, but my laptop hp official said 72?olor gamut, but I think 45 color gamut closer to the mark. The official lie Series 2333
In conclusion from my side of view seems to really enhance the quality, performance seems to have improved a little bit of it. Perhaps the psychological effect, but actually better than the built-in renderer, potplayer said built-in renderer has been good enough, do not use external renderers In this case, the programmer may have been a routine, because they know who use your product. If you are a regular user, then most will believe it, then do not tamper with, this usually will not set the error caused by software problems. But for veteran drivers, they can render the best decoder to throw inside, although a 2333 short, is not to do things not sure, things do get out of losing control, Mao did not stop the Cultural Revolution wave Well, so be sure to ensure that the above settings are correct, and do not blindly imitate me, just in case your monitor more advanced, you can choose 10bit it? In case your monitor is calibrated, and they chose not calibrated, it would mean loss? In conclusion know a thing or a little better.
Well, do not care much said, this is the case, I say good Night on the Galactic Railroad, next time 2333
I still think this frame rate has BUG, ??do not believe you can see:
Refresh my broken card 400 times per second, shall not be bombed?
Copyright Protection: ShuDudu from the original article, reproduced Please keep the link: https://www.shududu.com/other/i5-4210U-GT840M-renderer-using-MadVR.htm