In the "IPS screen and bought a raspberry pie Metal Jacket" this article, I said buy an IPS screen, then strapped on with a simple bracket, although can be used, but it does not look good, rotating movements are troublesome, also take up space, so whenever you re-engage in a recent case:

Internet to buy a monitor base (liftable and vertical screen) and a custom acrylic plate (same size and the periphery of the screen), according to their needs acrylic opening for accommodating a screw. Select the screw holes screw according to the four corners of the screen, I used here M2x15mm double pass Tongzhu do intervals, M2x5x0.3 M2x6mm screws and washers. Good driver board design and location of the button, I am here to drive plate on the bottom button on the left side. Used M3x10mm copper pillars and M3x6mm screws. VISE pitch is standard monitor stand, a good start with the drill hole is fixed acrylic plate using M4 and M4 screw nut.

I had to buy a Dell monitor base, but it is too expensive, and now the base is not good-looking, but you can convert the screen anyway, but also very stable, there is a large tilt angle required some effort to do the adjustment.